![background image](http://html.mh-extra.com/html/nec/express5800-110ri-1/express5800-110ri-1_user-manual_251179257.webp)
Upgrading Your Server 9-9
DEVICE INSTALLATION OR REMOVAL PROCEDURE
Install or remove a component from the server in the following procedure.
Hard Disk Drive
The server can contain up to three hard disk drives.
The factory-set hard disk drive uses serial ATA interface.
IMPORTANT:
Do not use any hard disk drives that are not authorized by NEC.
Installing a third-party hard disk drive may cause a failure of the
server as well as the hard disk drive.
All hard disk drives must accept the same interface.
Jumper switch setting on backplane board may need to be changed
depending on hard disk drive type. Set the switch appropriately
according to the figure below.
For N8103-116/117/118, leave the factory setting (SATA HDD
LED) as is.
Disk bay 2
For second hard disk drive
Disk bay 1
For first hard disk drive
Disk bay 3
For third hard disk drive
Mother board
Backplane board
SATA HDD LED
SAS HDD LED
Strapped
Strapped
Summary of Contents for Express5800/110Ri-1
