NEC EXPRESS 320Lb, User Manual

Page: 126 / 181

Problem Solving 5-3
Troubleshooting Checklists
The following subsections provide troubleshooting checklists for problems that occur at
initial system startup, when you run new application software, and after the system
hardware and software have been running correctly.
Initial System Startup
Incorrect installation or configuration usually causes problems that occur at initial
system startup. Hardware failure is a less frequent cause. If you have problems during
initial system startup, review the following checklist.
Checklist
!
Are the system power cords properly connected to the system and plugged into a
NEMA 5-15R outlet (100-120 VAC), a NEMA 6-15R outlet (200-240 VAC), or an
UPS that meets the power specifications of the system?
!
Is AC power available at the wall outlet?
!
Did you press the power on/off push-button switch on the PCI Module to turn the
system on (power on LED should be lit)?
!
Are all cables correctly connected and secured?
!
Are all jumpers and switch settings on option boards and peripheral devices correct?
To check these settings, refer to the manufacturer’s documentation that comes with
them. If applicable, ensure that there are no conflicts; for example, two option boards
sharing the same interrupt.
!
Are all switch and jumper settings on internal boards and drives correct?
!
Are the CPU modules and PCI modules fully seated in their bays? Refer to Chapter 4
for installation instructions?
!
Are all peripheral devices installed correctly?
!
Are all option boards and disk drives installed correctly
!
Is the system hard disk drive properly formatted or configured?
!
Is the operating system properly loaded? Refer to the operating system
documentation.
!
Are all drivers properly installed? For information about installing drivers, refer to
your
Network Operating System Configuration Guide .
!
Are the configuration settings in BIOS Setup and the SCSISelcet Utility correct? For
information about running these utilities, refer to the
Configuring Your System
chapter 3.
If the above items are all correct, but the problem reoccurs, refer to Diagnostic
Procedures in this chapter.