EdgeMarc 4500 SOHO Router Installation Guide
5
Back Panel
Figure 2: NEC EdgeMarc 4500 Back Panel
Name
Description
A
Power Connector
Accepts the plug from the supplied power cord to connect the unit
to an AC power source
B
10/100 Mbps LAN
Ports
Local Area Network (LAN) ports to connect the IP phones or an
Ethernet switch. Unit can also be configure through any of these
ports using the web interface
C
USB Ports
2 x USB ports (Not Used)
D
Ethernet WAN
Port
This port is typically used when connecting the EdgeMarc 4500 to
a cable or xDSL modem.
E
Management
Console Port
This port is used to establish a local console session with the
EdgeMarc 4500 using a VT100 terminal or emulation program.
The cable required is a straight-through 8-wire cable. The serial
port uses a baud rate of 9600, 8 data bits, 1 stop bit and no parity.
This port is used for debug or local diagnostic purposes only.
Primary configuration of the EdgeMarc 4500 is performed from a
web browser as covered in
VOS User Manual
