Setting Up The Networking Feature
Numbering Plan
32
◆
Networking
Numbering Plan
Numbering Plan
➻
11-01-01 : System Numbering
Set the system’s internal (Intercom) numbering plan and system ID to route to networked sys-
tems. The numbering plan assigns the
Þ
rst and second digits dialed and affects the digits an
extension user must dial to access other extensions and features, such as service codes and
trunk codes, within a networking node or to reach another node.
Consider using a "Uni
Þ
ed Numbering Plan" for extensions. This gives every extension in the
network a unique extension number. The extension number can then be used to route a call to
the proper node. This also allows the same extension number to be dialed at any node to reach
a given extension.
PRI Networking With Two Local Voice Mails, Masters Must Have Different
Numbering
When programming a PRI network with each system having their own local voice mail, the
master numbers for the voice mails must be de
Þ
ned in different series in Program 11-01. The
second digit of the extension number can not be the same. For example, 7
0
0 and 7
0
1 will not
work, however 7
0
0 and 7
1
0 can be used.
Changing the numbering plan consists of three steps:
Step 1: Enter the digit(s) you want to change
You can make either single or two digit entries. In the Dialed Number column in the
(page 133) table, the nX rows (e.g., 1X) are for single digit codes. The remaining
rows (e.g., 11, 12, etc.) are for two digit codes.
●
Entering a single digit affects all the Dialed Number entries beginning with that digit. For
example, entering 6 affects all number plan entries beginning with 6. The entries you make
in step 2 and step 3 below affect the entire range of numbers beginning with 6. (For exam-
ple, if you enter 3 in step 2 the entries affected would be 600-699. If you enter 4 in step 2
below, the entries affected would be 6000-6999.)
CAUTION
Improperly programming this option can adversely affect system operation. Make
sure you thoroughly understand the default numbering plan before proceeding. If you
must change the standard numbering, use the chart for
(page 133) to keep careful and accurate records of your changes.
Before changing your numbering plan, use the PC Program or Program 90-03 to
make a backup copy of your system’s data.
1.
Enter the digits you want to change.
2.
Specify the length of the code you select to change.
3.
Assign a function to the code selected.
Summary of Contents for Aspire L
