78K0/Lx3 - See it!
User’s Manual
U18759EE2V0UM00
73
Before using the On-Board debug function it is necessary to set the corresponding USB serial COM port of
the host computer where the
78K0/Lx3 - See it!
board is connected. To set the COM port, please select the
category “TK-78” and choose the corresponding serial port.
Figure 70: IAR debugger options 2/2
Next the correct linker settings of the demo project will be checked. This can be done in the “Linker”
category as shown below. Select the “Config” tab and check that the linker command file “lnk78f0495.xcl” is
selected. This file is used by the linker and contains information on where to place the different sections of
code and data that may be used within the demo project.
Figure 71: IAR Linker options
Choose serial port
