Quick Start
To attach the MultiSync
®
LCD monitor to your system, follow these
instructions:
1. Turn off the power to your computer.
2. For the PC: Connect the 15-pin mini D-SUB of the appropriate signal cable
to the connector of the display card in your system
(Figure A.1)
. Tighten all screws.
For the Mac: Connect the MultiSync LCD
1530V
™
Macintosh cable adapter to the computer
(Figure B.1)
. Attach the 15-pin mini D-SUB end of the appropriate signal cable to the
MultiSync LCD
1530V
Macintosh cable adapter
(Figure B.1)
. Tighten all screws.
NOTE: To obtain the MultiSync LCD
1530V
Macintosh cable adapter,
call NEC-Mitsubishi Electronics Display at (800) 820-1230.
Remove connector cover and cable cover on back of monitor.
3. Connect the 15-pin mini D-SUB of the video signal cable to the appropriate connector on
the back of the monitor
(Figure C.1)
.
NOTE: Incorrect cable connections may result in irregular operation, damage
display quality/components of LCD module and/or shorten the module’s life.
4. Connect one end of the power cord to the MultiSync LCD Series monitor and the other
end to the power outlet. Place the Video Signal Cable and AC power cord under Clips
(Figure C.1).
Replace connector cover and cable cover.
(Figure E.1)
NOTE: Adjust position of cable that place under clips, to avoid damage for cable or
monitor.
5. Turn on the monitor
(Figure D.1)
and the computer.
6. To complete the setup of your MultiSync LCD monitor, use the following OSM
™
controls:
• Auto Adjust Contrast
• Auto Adjust
Refer to the
Controls
section of this User’s Manual for a full description of these OSM controls.
NOTE: For download information on the Windows 95/98 INF file for your MultiSync
LCD
1530V
monitor, refer to the
References
section of this User’s Manual.
NOTE: If you have any problems, please refer to the
Troubleshooting
section of
this User’s Manual.
NOTE: For easy removal of the cable cover or signal cable, place the monitor face
down.
(Figure R.2)
3
1530v
0.9.25, 5:12 PM
5
ブラック
