- 11 -
Generally, AMX100 is installed behind the TV, under the conference table, in the cabinet,
etc. However, as AMX100 is the HUB node of each component of the A40 package, it
involves:
The new AMX100 is equipped with a power adapter with a power cord, and a 3-meter USB
cable from USB-B to USB-A.
To connect with ACT10, should buy extra network UTP cable.
To connect with ASP100/110 Speaker, should buy extra speaker cables.
If the conference host terminal/speaker's laptop is far away from the AMX100, then need to
consider purchasing additional USB extension cables or transferring via the ground plug
network.
When connecting with A/V system (audio processor/mixer/handheld microphone receiver)
and hardware video terminals, the AMX100 side will use unbalanced 3.5 audio interfaces
and 6.35 audio interfaces. But the other side is usually a balanced Canon interface and
Phoenix terminal interface. Therefore, additional 3.5/6.35 XLR, 3.5/6.35 Phoenix terminal
and other conversion cables need to be prepared (pay attention to male and female at
both ends).
In addition, due to strong electric magnetic leakage, quality of interconnecting cables,
potential difference between two devices and other factors, unbalanced signals are easily
to get interference and generate current noise. In this case, it is necessary to purchase a
noise eliminator isolator to be connected in series in the interconnection cable to solve the
problem of current noise.
PS: The 6.35mm input port will be designed to balanced type the next batch of production.
Therefore, it is necessary to consider and determine the installation location of the
AMX100 by integrating the above factors.
2.3 AMX100 Installation position/mode
Network cable length and cabling mode with multiple A40s.
Audio cable length and wiring mode with multiple wall mounted louder-speakers
ASP110.
Length and cabling method of USB cable with conference host terminal/smart white-
board OPS/speaker's laptop.
Length and cabling mode of audio cable integrated with equipment in A/V cabinet (if
there’s 3rd party A/V system integration).
The length and cabling mode of the audio cable integrated with the traditional video
conference terminal (if there’s 3rd party conference system integration).
2.3.1 Cable length/cabling
2.3.2 Adapter/auxiliary materials
