NDS ScaleOR, User Manual

Page: 13 / 36

VGA
S-Video / Composite
DVI-D 3G-SDI
Removable Input Modules
Input Modules:
Four types of input modules are available: DVI-D , 3G-SDI , VGA and S-Video / Composite
The DVI-D input module accepts DVI signals up to 1920 x 1200 progressive at 60Hz.
The 3G-SDI input module accepts SDI signals up to 1920 x 1080 progressive at 60Hz.
The VGA input module accepts analog signals up to 1920 x 1200 progressive at 60Hz.
The S-Video / Composite input module accepts S-Video / Composite NTSC or PAL signals .
Any one of the input modules shown below may be installed in the card slot.
Module Removal and Installation
The ScaleOR must be turned off prior to installing or replacing the input module.
Input Module Removal:
Use a number 1 Phillips screwdriver to loosen, but not remove, the screws located on the left and right
sides of the module’s mounting plate. When the screws are clear of the chassis, remove the module by
gripping the screws and pulling the module out.
Installation:
Slide the new module into the chassis until it contacts the connector, then push gently until the module
seats. The module is correctly seated when its mounting plate is flush with the chassis’s back panel. Thread
the module’s screws into the chassis until they touch the mounting plate, then tighten each screw by
turning it another quarter turn.
6
VGA Module Switches
Function Switch 1 Switch 2 Switch 3
RGBS On On Off
YPbPr Off On Off
VGA On Off Off
SOG Off Off Off
OSM / RS-232 Off Off On
1. To select the Input Format using the OSM or via
Serial control switch 3 must be On . When switch 3
is On switches 1 and 2 are disabled.
2. To select the input format manually turn switch 3
Off . Then, using the table to the left, set switches 1
and 2 to the format of the input signal.