NDS ScaleOR, User Manual

Page: 10 / 36

3
3
Electrical Symbols
Connector Panel
Output Mode Switches
The Output Mode Switches , accessible on
the underside of the unit, allow the user to
select 1 of 46 output modes. The
Output
Mode Switch Settings table on the
following page shows the switch settings
required to select a given output mode.
Setting the output mode from the
On
Screen Menu ( OSM ) requires that all
switches be set to off.
Notes:
Power input, use the provided 12VDC power supply only.
Optional
Fiber Optic output
Input module,
DVI-D module shown, all input modules are shown on page 6.
The
ND-OS connector allows the ScaleOR to be controlled remotely via serial commands. It is also used
to install BIOS upgrades.
SDI and DVI video outputs.
Power Switch:
The Power Switch symbol is shown to the left.
The power switch is push on / push off and is shown below the Power Switch symbol.
When the switch is off the ring around the center portion is white. When the switch is on,
the center portion is depressed and the ring is illuminated blue. The illustration shows the
switch in its
ON state. When the ScaleOR is turned on the blue ring flashes at the rate of 5
flashes per second for 15 seconds then, becomes steady if a video signal is detected. If a
video signal is not detected the ring continues flashing at the rate of 1 flash per second.