N
BOT, NDI Motorized Head
8
•
Robotic Pan / Tilt Head
Input
•
Supports Sony VISCA operation via Ethernet connection
•
POE+ (Power over Ethernet – 802.3at) support
•
HDMI video/audio input
Pan
Turning radius 170 degrees to the right and 170 degrees to the left ( 340 degrees )
** 360 degrees possible when the sensor is off**
Speed: 180 degrees in 10 seconds (Variable speed in 1~24 steps)
Tilt
Turning radius up 20 degrees down 35 degrees
Speed: 15 degrees per second (Variable speed from 1 to 24 steps)
Preset
10 position Save
Save Pan/Tilt Position Save , Speed Save
Zoom In/Out Position Save , Speed Save Pan/Tilt 1/3 ( at Zoom Servo)
Ex-Control
1.LANC input Camera
Remotely control Zoom In/Out ( Speed 1~12 step ), Focus
2. Sony Multi Control (option)
3. Zoom Servo Control (option)
Tally
Internal / external Tally support
Output
NDI output to IP over Ethernet connection
1080p60 full HD resolution support
Tally Light
LANC , Sony Multi , Zoom Servo
Management
Front status LED support
Support rear USB port service terminal
Support for remote firmware update
Physis
Dimension : 128(H) X 157(W) X 157(D)
Operation Temperature : 0~45
℃
Weight : 1.87 Kg
Power Consumption: Max 30W
Input Voltage AC220V 60Hz/ AC110V 60Hz/AC 24V 60Hz Power Consumption PAN: 4.4W TILT: 4.4WP/T Operating Speed Left/Right
Rotation Speed: 5
°
/sec Up/Down Rotation Speed: 2
°
/sec P/T Operation Angle Left/Right Rotation Angle:
0
°
∼
340
°
Up/Down Rotation Angle: +45
°
∼
-85
°
Operating Temperature -20
°
C
∼
+50
°
C Operating Humidity Less than 90% Accurate
Load 5Kg Color IVORY Dimensions 152 (L)X147(H)X215(W) Material ABS & ALUMINUM PLATE Weight Approx. 2.2K
.
Installation Precautions • It is recommended to install so that the height of the center of the housing at the top of the CAMERA
MOUNT BASE is less than 50mm. Cause • Do not exceed the loading weight (5kg) of this PAN-TILT and install it so that the center of
the housing member coincides with the center of this PAN-TILT. How to operate TILT (upper, lower) angle In the figure above, if you
loosen two bolts in the part where the label is drawn, you can see two bolts in the half-moon-shaped groove. Loosen these two bolts
2-3 turns to adjust to the desired angle position, and tighten so that it does not loosen, the angle adjustment is successful. How to
operate the PAN (left, right) angle SPT-510 There are two bolts on the top of the connector at the bottom of the outside. Loosen
these two bolts 2-3 turns to adjust them to the desired angle and tighten them so that they do not loosen
.
3. Technical Specification
