NCR NCR S16, Installation Manual, Page: 70 / 108

Rebooting the Server and Installing the Operating System
8-4 Installing SCO UNIX
Rebooting the Server and Installing the
Operating System
To reboot the server, follow these steps:
1. Insert the N1 disk into the system, and boot the server.
2. For SCO Release 5, at the BOOT: prompt, press Enter. When prompted,
select the installation media of choice.
3. For SCO Release 3, at the BOOT: prompt, enter “link.” Then, at the
What packages? prompt, enter “alad” for the AIC-7880 Adapter, or
“mdac” for the Mylex Adapter.
4. For SCO Release 3, insert the proper BTLD disk when prompted. The
correct BTLD is supplied from Mylex or Adaptec. The Adaptec alad
driver is also available on the SCO Advanced Hardware Supplement 3.4
disk, but not the Mylex driver (at this time). Observe the system message
that the BTLD was successfully loaded before going to the next step.
5. For SCO Release 3, insert the N2 (file system) disk when prompted.
6. For SCO Release 3, reinsert the N1 disk when prompted.
7. Select Keyboard type.
8. Enter the serial number and activation key code using the exact syntax on
the yellow tag.
Entering Setup Information
To enter setup information, follow these steps:
1. At the Installation Setup screen, select Overwrite (entire primary hard
drive).
2. At the Software Setup screen, enter a unique name or use “scosysv,”
which is the default for the system name. The default selection for Domain
Name is normally okay.
3. At the Software Setup screen, select Traditional Security.