NCR NCR S16, Installation Manual, Page: 43 / 108

Performing a Full Installation of Windows NT Server 4.0
NCR S16 Minitower Server Installing Network Operating System 5-7
Performing a Full Installation of Windows
NT Server 4.0
To install Windows NT Server 4.0, follow these steps:
1. Insert the Windows NT Server Setup Boot Disk into the flex disk drive.
Power on the system.
2. When prompted, insert the Windows NT Server Setup Disk 2 and press
Enter.
Entering Windows Setup
To enter Windows Setup and proceed, follow these steps:
1. When prompted to setup Windows now, press Enter.
2. When prompted, press Enter to have setup detect the mass storage
devices. Your system is then inspected to determine which mass storage
devices are installed.
3. When prompted, insert the Windows NT Server Setup Disk 3. and press
Enter.
4. Upon completion of the inspection process, you are informed which SCSI
host adapter boards have been detected by the NT setup procedure. If the
boards are not auto-detected, you are given the opportunity to manually
add them. Some drivers may not be auto-detected.
5. Included in the list should be the Adaptec AHA-294x/AHA-394x/AIC-
78xx SCSI adapter. This adapter is embedded in the main system board of
the server. Any additional adapters which are installed in your system
should also be listed. Press Enter to accept this list of devices.
6. A screen message may display indicating that your hard disk has more
than 1024 cylinders. Read the message and press Enter.
7. When prompted, read the Microsoft License Agreement. Press Page
Down until you have read all of it, and press F8 or Esc.