NCR 7455, Hardware User'S Manual

Page: 79 / 144

Chapter 3: Setup 3-5
Legacy Diskette
The terminal does not have a flex disk drive. Therefore, this option is
unused, even though Setup defaults to 1.44 MB, 3 ½".
Primary Master
After installing a new hard drive, the system should automatically
detect the drive. If this is not done automatically and you need to
configure the IDE Adapter, perform the following steps:
1. Move the cursor to Primary Master and press Enter to access the
following submenu.
Type: [Auto]
CHS Format
Cylinders: [12416]
Heads: [ 15]
Sectors: [63]
Maximum Capacity: 6007MB
LBA Format
Multi-Sector Transfers: [16 Sectors]
LBA Mode Control: [Enabled]
32 Bit I/O: [Disabled]
Transfer Mode: [FPIO 4/DMA 2]
Ultra DMA Mode: [Mode 2]
2. Use the F5 and F6 keys to select the Type of hard disk. If Auto is
selected, the fields are automatically filled, based on the installed
drive.
3. Press ESC to return to the Main Menu.
4. Move the cursor to the Exit Menu, select Exit Saving Changes or Save
Changes, and press Enter.
Main Exit Submenu
PhoenixBIOS Setup Utility