P a g e
56 | 61
9
– Temporary and permanent shutdown
9.1
Temporary shutdown
The machine does not have any special requirements for preservation during 6 months from
the shutdown when storage conditions stated in Section 3 are met. Prior to the shutdown,
drain the machine and clean it according to Section 5.7.
Shutting down of the machine for more than 6 months may have an effect on the insulation
resistance of the heating body as a result of moisture condensation. Dry the machine
according to the instruction IN-1/ 97 Trefal.
9.2
Permanent shutdown
At the end of the machine service life, it is necessary to proceed in accordance with Act No.
541/2021 Coll. on waste management in the sense of Section 4, Section 13. If the machine
service life expires outside the Czech Republic, proceed according to the national regulation at
the place of disposal.
9.2.1
Dismounting the machine from the place of installation
Before any dismounting, always disconnect the machine from the power mains.
- Drain the wash liquid and the skimmed oil; see in Section 5.9. Thoroughly clean the working
space of the machine of residues of the wash liquid and oil.
- Transport from the installation site shall be conducted in the same way as in the case of its
installation; see in Section 4.1.1.
9.2.2
Machine disposal in the Czech Republic (machine disposal in other countries shall be
conducted in accordance with locally applicable national regulations)
According to Annex No. 1 to Decree 8/2021 Coll., the starting document to determine a
method of disposal of parts and substances of the machine is “Catalogue of Waste”. The
following list contains the recommended waste code classification:
- If residues of the washing liquid are present in the machine, drain them according to the
instructions given in the Parts washers machine user manual, Section 5.7.
- The wash liquid including sludge is classified as waste with code number 11 01 14;
- Disassembled electrical installation is classified as waste with code number 20 01 36 and 07
02 17;
- Plastic and rubber parts are classified as waste with code number 20 01 39 and 07 02 99 01;
- Metal parts are classified as waste with code number 20 01 40 05;
Use prescribed protective equipment when handling parts
contaminated with the wash liquid. Familiarize yourself with
safety rules for the wash liquid handling.
CAUTION - Danger of eye or skin injury with mild up to serious
consequences!
Summary of Contents for ADS800
