P a g e
29 | 61
5.6 Oil removal from the wash liquid
This function applies to the machine fitted with an oil skimmer, see in Section 2.1.2.
When the wash liquid is heavily contaminated by the floating oil, start the oil skimmer by
turning the
S1 “OIL SKIMMER”
switch to
“I”
, see in Fig. 7. In this position, the oil skimmer
function is completely independent on other functions of the machine.
Therefore, regularly
check for the correct positioning of the collecting vessel under the outlet of the drain
channel draining the collected oil!
5.7
Draining the machine
Unscrew the safety plug (pos. 4-101) out of the drain valve, see in Fig. 4 (pos. 4-51) and open
the drain valve to drain the machine. When the liquid has been drained, open the machine lid
and remove both grids (pos. 1-71 and 1-72), see in Fig. 1. Use a pressure water hose to rinse
the bottom of the working group.
Remove the filter, see in Fig. 3a (pos. 3a-3) out of the suction duct and wash it on the outside
by water jet and flush its inside through the inlet opening if necessary. If the filter is damaged,
replace it with a new one!
Once the bottom of the working group has been cleaned, reinstall
the filter and the grids.
It is prohibited to operate the machine with a clogged or
damaged filter or without a filter.
CAUTION - there is a risk of clogging the pump with deposits,
deterioration of the washing capacity and damage
to the pump!
5.7.1
Cleaning the oil skimmer, see in Fig. 2a (pos. 2a-41).
Cleaning of the oil skimmer should be performed with wash liquid replacement. Drain the
machine and remove the cover (pos. 2a-71).
Disassemble the skimming belt from the oil skimmer drive (pos. 2a-101). Remove the balance
roller off its lower section (pos. 2a-5). Lift it above the drive roller (pos. 2a-7) and slide it out of
the teflon blades (pos. 2a-6). Use undiluted wash liquid and a water jet to clean the
disassembled belt, teflon blades and the drain channel. After cleaning, reinstall the
dismounted parts, switch on the machine and check that the belt is running smoothly. Finally,
reinstall the cover.
Take special caution when cleaning the working space of the
machine
immediately
after
stopping
the
technological
processes.
CAUTION - Risk of scalding by hot liquid or inhalation of hot
vapours!
5.8
Filling the machine with fresh wash liquid
Check that the drain valve, see in Fig. 4 (pos. 4-51), is closed and that the safety plug is
screwed in (pos. 4-101).
Open the machine lid and remove the grids from the floor, see in Fig. 1 (pos. 1-71 and 1-72).
According to the procedure provided on the package of the concentrated alkali solution of
Summary of Contents for ADS800
