TRACKFISH 6500
Installation and Operation Manual
76
NAVMAN
18-7 Installation: Navman petrol/gasoline sensors
Fit the optional petrol/gasoline fuel kit
following the instructions supplied with the kit.
Note:
SmartCraft engines have fuel flow sensors,
therefore Navman fuel sensors are not
required as well.
For dual engines, fit two kits.
Wire the TRACKFISH for auto power (see
section 18-4).
An optional GPS/fuel Y cable is required.
During setup:
a set Y cable to and set up Auto power off
(see sections 2-2 and 17-1)
b set the fuel data (see section 17-5)
GPS antenna (optional)
Fuel sensor cable
Yellow
Yellow
GPS/fuel Y cable
White
18-8 Installation: Navman diesel sensors
Fit the optional diesel fuel kit following the
instructions supplied with the kit. Note:
SmartCraft engines have fuel flow sensors,
therefore Navman diesel sensors are not
required as well.
For dual engines, fit two kits. Wire the two
diesel flow sensor cables in parallel.
Normally, power the diesel sensors
from the boat ignition switch. Then the
TRACKFISH does not need to be wired for
auto power (see section 18-4).
During setup:
a set
NavBus
to (see section 17-10
)
b set the fuel data (see section 17-5)
18-9 Installation: DSC VHF radio
Fit and set up the optional Navman DSC VHF
radio following the instructions supplied with
the radio. During setup:
a on the radio, enter buddy boats required
b on the TRACKFISH, set NavBus to (see
section 17-10)
Power/data cable
Orange
Blue
Diesel sensor cable
Black
Power/data cable
Orange
Blue
Radio power/data cable
Black
