G-PILOT 3100
Operation Manual
NAVMAN
14
GYBE ANG
The angle of course change in a
gybe (40° to 140° or AUTO or OFF, default =
AUTO) (see sections 4-5, 6.5).
TACK DELY
The delay between pressing
tack and the boat starting to tack (1 to 120
sec or OFF; default = 30 sec) (see sections
4-5, 6-5).
TURN RATE
Set the maximum boat turn rate
allowed, in degrees per sec (3 to 20, default =
10 degrees per sec).
VESSEL > menu
This menu can only be accessed in STBY.
VESL TYPE
Vessel type (SAIL, PLNE (planing),
DISP (displacement); default = SAIL).
DRVE TYPE
Steering drive type (MOTR, SPL-
or SPL+; default = MOTR) (see
G-PILOT 3100
Installation Manual
).
WIND TYPE
The wind type to use (APP or
TRUE; default = APP).
HDG TYPE
The compass heading type (MAG
or TRUE; default = MAG).
MAG VAR
The magnetic variation where the
boat is (90°W to +90°E; default = 19°E).
DEVICES > menu
The items in the DEVICES menu are functions
used to calibrate the G-PILOT 3100. This menu
can only be accessed in STBY.
RFU CAL
Start the procedure to calibrate
the rudder feedback unit (see
G-PILOT 3100
Installation Manual
).
RFU CENTR
Set rudder to position where
boat sails in a straight line (see
G-PILOT 3100
Installation Manual
).
CSU CAL
Start the procedure calibrate the
compass (see
G-PILOT 3100 Installation
Manual
).
ALIGN HDG
Align the compass with the boat
(see
G-PILOT 3100 Installation Manual
)
ALIGN GPS
Align the current boat heading
with a GPS heading (COG) if available (see
G-PILOT 3100 Installation Manual
).
FACTORY > menu
This menu can only be accessed in STBY.
BKL GROUP
NavBus group number (0, 1,
2, 3 or 4, default = 1) (see
G-PILOT 3100
Installation Manual
).
KEY BEEPS
A beep when a key is pressed
(ON or OFF, default = ON).
NMEA2 DAT
NMEA 2 port function (IN,
SLOW or FAST; default = IN):
IN
: NMEA 2 is an input
SLOW
: NMEA 2 outputs heading &
rudder angle once per second
FAST
: NMEA 2 outputs heading ten times
per second.
MCU VX.X
Displays the G-PILOT 3100 main
unit’s software version number (e.g. MCU V1.3
is version 1.3).
HCU VX.X
Displays the display unit’s software
version number (e.g. HCU V2.5 is version
2.5).
NVM RESET
This function resets all G-PILOT
3100 user data to the factory default values.
Once NVM RESET is displayed:
1 Press
>
to turn the function on
2 Press
ENT
to reset the data
3 Hold
ESC
to exit the menus
4 Perform the dockside setup and sea trials
to recalibrate the G-PILOT 3100 (see
G-PILOT 3100 Installation Manual
).
Summary of Contents for G-PILOT 3100
Page 2: ......
Page 35: ......
Page 36: ...G PILOT 3100 Operation NAVMAN Made in New Zealand MN0000213E Lon 174 44 535 E Lat 36 48 404 S...
