FISH 4350 / 4380
Installation and Operation Manual
11
NAVMAN
3-5 Setup > Logs
Press
MENU
twice to display the
Setup
menu,
then select
Logs
:
The values can be changed independently of
each other. These log values are saved when
the unit is turned off.
Reset trip dist (FISH 4380 only)
This resets the trip distance to zero.
Reset total dist (FISH 4380 only)
This option resets the total distance to zero.
Reset engine hours
Use this option to reset the engine hours to zero.
This can be useful after an engine service or to count
the engine hours between service intervals.
c Alarm Beeper Alarm condition is
Name Cycle met when the:
Too
1
/
5
sec depth is less than
shallow the alarm trigger value
Too
1
/
2
sec depth is greater than
deep the alarm trigger value
Fish 1 short echo matches the
Þ
sh
beep pro
Þ
le selected by
Þ
sh
Þ
lter
Temp.
1
/
2
sec temperature equals
the alarm trigger value
Temp.
1
/
2
sec rate of change of
rate temperature equals the
alarm trigger value
Low
1
/
2
sec battery voltage is
battery less than the alarm
trigger value
Low
1
/
2
sec fuel remaining equals
fuel the alarm trigger value.
3-6 Setup > Alarms
Press
MENU
twice to display the
Setup
menu,
then select
Alarms
:
Trigger settings can be de
Þ
ned to suit the boat
and individual preferences as follows:
Alarms can be set (enabled) to automatically
detect certain conditions, such as the water being
too shallow. Alarms that are enabled are shown
as black icons in the Alarm status box on the
sonar displays.
When an enabled alarm is triggered, the beeper
sounds, an alarm message is displayed and the
alarm status icon is shown in red.
Press or
MENU
to acknowledge the alarm,
stop the beeper and close the alarm window.
This does not disable the alarm.
Alarms automatically re-enable
The
Too shallow
,
Too Deep
and
Low
battery
alarms automatically re-enable
when the value moves outside the alarm
trigger setting.
The
Temperature
alarm automatically re-
enables when the temperature is more than
0.45°F (0.25°C) above or below the alarm
trigger setting.
The
Temperature rate
alarm automatically
re-enables when the rate of temperature
change falls below the trigger setting by more
than 0.2°F (0.1°C) per minute.
Flashing Light and/or External Beeper
(FISH 4380 only)
If a secondary alarm indicator is required, a
ß
ash-
ing light and/or external beeper can be installed.
These can be positioned anywhere suitable on
the boat. See section 6-4 Wiring options.
