Navman Fish 4350, Installation And Operation Manual

Page: 10 / 30

FISH 4350 / 4380 Installation and Operation Manual 10
NAVMAN
When asked
Are you sure?
select
Yes
.
Tank size
Enter the capacity of the fuel tank.
Num. engines
Set the number of engines to
0
,
1
or
2
. If
0
is
selected the fuel features are turned off.
Calibrate
See section 3-9 Setup > Calibrate.
Flow Þ lter
Most engines do not draw fuel from the tank at
a steady rate. To give a stable fuel
ß ow reading,
the Þ sh Þ nder calculates the ß ow value(s) by
taking several measurements and averaging
them. Use the Flow
Þ lter to set the period over
which the fuel ß ow is averaged.
For twin engine installations, the fuel ß ow for
each engine must be adjusted separately.
The Flow
Þ lter can be set from
0
to
10
seconds.
Use the lowest value which gives a stable ß ow.
Usually a value of 5 seconds (default setting)
will give a satisfactory result for two-stroke
carburettor engines.
This setting affects the
Fuel ß ow
and
Fuel
economy
reading on the Fuel display (see
section 5-5. Fuel display) but it does not affect
the
Fuel used
reading.
Tank full
Select
Tank full
each time the fuel tank(s)
are completely re Þ lled. When asked
Are you
sure?
select
Yes
. Otherwise, the reading
on the Fuel display (see section 5-5 Fuel
Display) and the Low Fuel Alarm (see section
3 -6 Setup > Alarms) are meaningless.
Set remaining
Before doing a partial re Þ ll of the tank or remov-
ing fuel manually from the tank (for example,
by siphoning it off):
1. Note the
Remaining
reading on the
Fuel display.
2. Note how much fuel is added or removed.
3. Calculate how much fuel is now in the
tank.
4. Select
Set remaining
and update
the reading.
It is essential to do this whenever some fuel
is added or removed. Otherwise, the reading
on the Fuel display (see section 5-5 Fuel
Display) and the Low Fuel Alarm (see section
3-6 Setup > Alarms) are meaningless.
Clear Used
Select
Clear used
to set
Used
(the amount
of fuel used) to zero. Do this to start measuring
the amount of fuel used over a certain time or
distance.
3-4 Setup > Data
Press MENU twice to display the
Setup
menu,
then select
Data
:
3. Press at any data Þ eld to show the list
of data items that can be displayed there.
4. Highlight the required data item and press
. The data item is immediately displayed
in that data Þ eld.
5. Press or MENU when Þ nished.
Time base
To change the Time base of the temperature
graph, select
Time base
and press . Choose
between 5 mins, 10 mins, 20 mins, 1 hour and
2 hours and press to con
Þ rm.
Data setup
To change data items (FISH 4380 only):
1. Select
Data setup
, and press
2. Use or
to move from data
Þ eld to
data Þ eld.