Version 26.01.2022
HW: CAM(100)/(V20/Y+V41)
CI-RL4-SY3
P
a
g
e
7
1.4.1.1.
Activating the front camera input (dip 1)
If set to ON, the interface switches for 10 seconds from the rear-view camera to the front
camera input after having disengaged the reverse gear. In addition, a manual switch-over to
the front camera input is possible via keypad (short press) from any image mode.
Description of the power supply output: see chapter “Power supply output”.
1.4.1.2.
Enabling the interface’s video inputs (dip 2-3)
Only the enabled video inputs can be accessed when switching through the interface’s video
sources. It is recommended to enable only the required inputs, disabled inputs
will be skipped when switching through the video-interfaces inputs.
1.4.1.3.
Activation of the Interface PDC Graphic (Dip 4)
Dip 4 is used to display the interface PDC graphic as „picture in picture“ in combination with
the camera image.
1.4.1.4.
Rear-view camera setting (dip 5)
If set to OFF, the interface switches to factory picture while the reverse gear is engaged to
display factory rear-view camera.
If set to ON, the interface switches to its rear-view camera input
„Camera-IN“
while the
reverse gear is engaged.
1.4.1.5.
Enabling the Guide lines (dip 6)
If set to ON, the interface is activated to show the guide lines for the rear-view camera while
the vehicle is in reverse mode (not available for all vehicles).
Note:
Some vehicles have a different code on the CAN-bus which the video-interface is not
compatible with. If the interface does not communicate completely with the vehicle CAN
bus, the reverse gear guide-lines and the PDC can`t be shown during the vehicle’s operation,
even if they in some vehicles once appear after having switched the system to powerless!
1.4.1.6.
Monitor selection (Dip 7)
Dip 7 is used to adjust to the corresponding monitor size.
If set to ON, 4 inch monitors are selected on the interface.
If set to OFF, 6.5-, 7- and 8inch monitors are selected on the interface.
Note:
Dip8 is out of function and has to be set to
OFF
.
After each Dip-switch-change a power-reset of the Video Interface has to be performed!
