NT888G MK2 AUTOPILOT OPERATING MANUAL
(iii) “±1° / ±5°” Step Turns (Section 2.13 & 2.36) … (Continued):-
To use the “±1°/±5°” function:-
a) Use the “
+
” (STBD) or “
-
“ (PORT) “TURN” key
to specify the direction of turn required in single
presses (for 1° course change steps) or hold
the key down to produce an increase in the
new heading step values automatically from 1°
to 5° to 10° etc.
b) Note that the actual amount of course change
ordered using the “TURN” keys is always
confirmed by the new permanent heading
shown in the “SET COURSE” area of the
display.
1.16 The Controls Menu (Section 2.4).
This Menu can be conveniently displayed during normal “STANDBY” or “ON”
operating modes by use of the “
CONTROLS
” key:-
Entry to the CONTROLS Menu is confirmed by a listing
from “ADAPT” to “TURN TYPE” (as shown) and selection
of the parameter required is via further
CONTROL
key
operation.
When the required item is highlighted by the blue bar, the
value – or state – of that item is set by movement (+/-) of
the rotary illumination control.
NB.
In the event that the
CONTROLS
Menu has been entered but no change has
been made for timeout period of 30 seconds, the display will revert automatically to its
normal operating mode.
1.17 The Limits Menu (Section 2.6).
This Menu can be conveniently displayed during normal “STANDBY” or “ON”
operating modes by use of the “
LIMITS
” key:-
Entry to the LIMITS Menu is confirmed by a listing from
“RUD LT” to “RAD:NM” (as shown) and selection of the
parameter required is via further
LIMIT
key operation
When the required item is highlighted by the blue bar, the
value – or state – of that item is set by movement (+/-) of
the rotary illumination control.
STEP ALIGN
002.5
