20 |
Configuration |
Loop S User Manual
If selected the fuse list button will be shown at the top of the MFD control bar. Refer to “Fuses”
on page 23.
D
Use OP-Box
(Loop S/S+ only)
Enabled if an OP-Box is used instead of an AT30 protocol converter (not covered by this
manual).
Edit channels/output settings
D
B
C
F
H
G
A
E
A
Egon+ board(s)
Select the Egon+ board you want to configure (for configuration with two Egon+ boards).
B
Output/Channel number
Indicates the output associated to the row.
C
Fuse/relay identification
Indicates the Fuse/Relay associated to the channel/output.
D
Image
Select an appropriate image for the connected equipment. When the icon is clicked a dialog
with available options will be shown. This image will be shown in the MFD software.
E
Description
Enter a name that describes the connected equipment. This name will be shown in the MFD
software.
F
Enable
Enable/Disable the channel/output.
G
Toggle
(not applicable for fuse outputs)
If selected, the button in the MFD software will be a toggle button. If not selected, the button
in the MFD software will be a momentary button (the output is active as long as the button is
pressed).
H
Bypass/Ext
(not applicable for fuse outputs)
Select if a bypass is connected to the relay or if the connected device can be manually or
automatically controlled by an external switch. For connection examples, refer to “Connection
examples” on page 14.
