| 9
Installation |
Loop S User Manual
C
Terminator
D
Power supply
E
Backbone
F
AT30 protocol converter (NMEA 2000 to Naviop CAN)
Naviop CAN network
The Naviop CAN network consists of a backbone from which drop cables connect to the
Egon+ board(s). Each Egon+ board is identified by a CAN ID displayed on the drop-cable.
The Naviop CAN network uses the same components as a NEMA 2000 network, however
the two networks shall not be directly connected to each other. The AT30 protocol converter
should be installed as a bridge between the networks.
E
C
C
A
D
B
E
D
A
AT30 protocol converter (NMEA 2000 to Naviop CAN)
B
Naviop CAN network backbone
C
Terminators
D
Drop-cables, maximum length 1.8 m (6 ft)
E
Egon+ boards (maximum 2 Egon+ boards can be installed)
Example
F
F
A
C
C
H
B
D
E
H
I
G
12 V
12 V
12 V
A
AT30 protocol converter (NMEA 2000 to Naviop CAN)
B
Naviop CAN backbone
C
Terminators
D
Egon+ drop-cable CAN ID:1
E
Egon+ drop-cable CAN ID:2 (only available for Loop S+)
F
Egon+ boards (maximum 2 Egon+ boards can be installed)
G
T-connectors
H
NMEA2000 backbone
I
MFD
