User’s manual NAVIGON 81xx
Before you begin
- 11 -
Caution!
After installation, check all safety-relevant equipment in the
car.
Caution!
Connect the car charger cable only to 10-30V cigarette
lighters.
Caution!
Disconnect the car charger cable from the cigarette lighter
whenever you park the car. The integrated mains adapter always
consumes a small amount of energy and could drain the car battery.
2.4
Preparing the NAVIGON 81xx for use
2.4.1
Assembling the mains adapter
The mains adapter has an operating voltage of 100~240V. Several
different plug adapters are provided. Charging the navigation device
when abroad is therefore no problem.
►
Push the correct plug adapter for the country in question into the
slot on the mains adapter until it locks in place.
2.4.2
Charging the rechargeable battery
It is possible that the rechargeable battery is not fully charged when you
unpack the navigation device. We recommend that you fully charge the
battery before using the device for the first time.
►
Connect the mains adapter to the navigation device and to a mains
socket.
Note:
Without delay, plug the USB connector into the navigation device
as far it will go! (See "Troubleshooting" on page 68)
During charging, the LED on the bottom of the
NAVIGON 81xx
shines
with an orange light.
The LED goes out again when the
NAVIGON 81xx
is fully charged.
Note:
When the bluetooth function of the
NAVIGON 81xx
is active, the
LED shines with a blue light. This is also the case during charging.
For detailed information refer to chapter "Handsfree Module" on
page 51.
Note:
It takes approx. 4-5 hours to charge the device when the battery
is flat.
