USER MANUAL
NAVWATCH-S10
8 |
P a g e
SETTING UP THE DATE AND TIME
Following from the Time Zone setting, you now have two clocks that need to be set.
These are again, called T1 (day name) and T2.
Note 1: If your global location does not support time auto-update you may be required
to manually set the time.
GPS updating
1.
Move outside to a location with clear line of sight to the sky. It is preferable to
be away from any surrounding buildings or structures that may inhibit the GPS
signal.
2.
From the time screen, press and hold the REC button until
the date read out (not the time read out) disappears and
is replaced with 00 (two zeros). The screen will display the
letters GET. The device has now started searching for GPS
satellite signals.
3.
As contact is made with each satellite this number 00 will
start to increase, to as much as 10-15 depending on your
area and conditions. Once the device has confirmed your
location co-ordinates, they will be momentarily displayed
on the screen.
4.
Your current location date and time will now be updated to your watch.
Note 1: You can re-view your location co-ordinates by pressing the REC button (twice)
from the time screen. The first press will take you past a screen titled GET which shows
the last time and date your co-ordinates were updated. You can then press the MODE
button again to take you back to the time screen.)
Note 2: It is suggested that you remain still while this initial GPS satellite connection is
made.
