Nautilus Instinct Multi-Press, Owner'S Manual, Page: 7 / 20

NAUTILUS INSTINCT MULTI-PRESS O
WNER
’
S
M
ANUAL
7
ASSEMBLY
1. Assemble the Main Frame to the Weight Frame
Align the two drilled holes in the lower
crossbeam (14) with the mating holes in the
bottom of the weight stack frame (1). Secure
the crossbeam to the weight frame using two
screws (46), four washers (65), and two lock
nuts (62). Tighten the nuts securely.
Align the two drilled holes in the upper
crossbeam (3) at the "short leg" with the
mating holes in the side beam of the weight
stack frame (1). Secure the crossbeam to the
weight frame using two screws (48), four
washers (65), and two lock nuts (62). Tighten
the nuts securely.
Position the main frame (2) so the two drilled
holes in the lower crossbeam (14) and the two
drilled holes in the upper crossbeam (3) are
aligned with the mating holes in the main
frame.
Secure the main frame to the lower crossbeam
using two screws (46), four washers (65), and
two lock nuts (62). Tighten the nuts securely.
Secure the main frame to the upper crossbeam
using two screws (46), four washers (65), and
two lock nuts (62). Tighten the nuts securely.
2. Install the Leverage Arm
NOTE:
Two people are required to install the
leverage arm; one to hold the leverage arm in
position, and one to install the leverage arm
shaft.
Pull out on the pull pin in the leverage arm
support (5) (factory installed) to retract the
locking pin, and hold in the retracted position.
Hold the leverage arm (6) in place between
the two shaft support bearings in the leverage
arm support (5).
Insert the leverage arm shaft (15) through
the leverage arm and both support bearings.
Secure the leverage arm shaft (15) to the
leverage arm support (5) using two screws (53)
and end caps (20). Release the pull pin, and
adjust the position of the leverage arm until
the licking pin engages the leverage arm
ratchet.
Rotate the leverage arm down until it rests
against the stop on the main frame.