![background image](http://html1.mh-extra.com/html/nautilus-hyosung/monimax5300/monimax5300_service-manual_3516485125.webp)
Service Manual Chapter8. CDU
© 2016
Nautilus Hyosung Inc.
All Rights Reserved.
8-19
Remaining Note Sensor
► CS6 / CS16 / CS26 / CS42
1. Remove the CS6 sensor from the main B/D to replace it. (See the main B/D
replacement section)
2. Remove the sensor bracket M3 screws (2 places each).
3. Press the snap lock in the rear of the sensor bracket with your hand and, then
remove the sensor
4. Remove the connector. Be careful not to break the connector pin when removing.
5. Replace the sensor.
6. Connect the connector.
7. To assemble the sensor in the bracket, lock it from the front side and press the rear
side to fix it.
<Note!>
Adjust the sensor by running the variable resistance so that it generates a
current below 1.0V if there is cash available and above 3.0V if no cash is available.