Nautel NX25, Operation And Maintenance Manual

Page: 96 / 162

NX300 Operations and Maintenance Manual Operating the transmitter
Page 2-78 Issue 3.0 2012-11-01
Configuring Exgine settings
The Exgine Settings option allows you to set signal parameters and determine IP information for use
with the Exgine option (see Figure 2.56 , Figure 2.57 , Figure 2.58 ).
Procedure to configure Exgine settings:
1. Open the
User Settings
page by pressing
Menu > User Settings
in the
Home
page.
2. Select the Exgine Configuration option (left-side of the screen) to display a list of pre-existing
notifications in the center of the screen. The Exgine window has multiple tabs (
IP
,
Mode
and
Tuning
) that you display by selecting the tab.
3. In the
IP
tab (see Figure 2.56 ), enter the following parameters and press
Apply
.
•
Protocol -
Selects the E2X protocol to use UDP or TCP. Match this setting to the exporter configuration.
• Exgine IP, Netmask and Gateway -
Configure the Exgine's IP network parameters as assigned by the local
network administrator. If no gateway is used or assigned, enter 0.0.0.0
.
• Exporter IP -
Enter the exporter's IP address of the interface where the data stream is originating. It is used
to filter E2X traffic in case multiple exporters are used in broadcast mode on a single LAN. 0.0.0.0 is also a
valid configuration
.
• E2X Port -
The exgine expects E2X on port 9000. Some non-Nautel Exporters utilize port 11000
instead.
•
Mac Address -
Displays a number that serves as unique network adapter identifier. This is set by
the manufacturer and is displayed for informational purposes only. It may be necessary to use this
number to allow the AUI to access your network
Figure 2.56: User Settings - Exgine Settings - IP Tab