Nautel NX25, Operation And Maintenance Manual

Page: 100 / 162

NX300 Operations and Maintenance Manual Operating the transmitter
Page 2-82 Issue 3.0 2012-11-01
• Trap Receiver IP : Enter the IP address of the computer to which the SNMP agent will
send trap notifications. The computer must be running an SNMP application that is
configured to receive traps. The SNMP agent will send trap notifications to at most one
receiver.
• Trap Receiver Port: Enter the UDP port where the SNMP agent will send traps. The
default setting is 162.
3. When complete click
Apply
or click
Cancel
to restore the previous settings.
Traps Settings
A trap is a message sent by an SNMP agent to an SNMP client when an alarm changes state (turns on
or off). The message is an SNMP packet that can be interpreted and displayed by an SNMP client
application. Using the Traps tab (see
Figure 2.60 ) select your desired traps as follows:
1. Find the desired alarm(s) by selecting the appropriate Device type (Controller, Exciter, Rack,
etc.) and scrolling through the Available Traps list. Add or remove traps to and from the
Selected Traps list using the >> and << arrow buttons
2. When complete click
Apply
or click
Cancel
to restore the previous setting.
Figure 2.60: User Settings - SNMP Configuration - Traps Tab