
GV10/GV7.5 TROUBLESHOOTING MANUAL
RESPONDING TO ALARMS
VERSION 3.2 2016-03-10
PAGE 4.1.67
4.
From the front of the transmitter, remove the two M5 screws that secure the exciter module to the
transmitter and pull out the exciter module. If you are replacing the exciter module’s exciter/control
PWB (A1), see
“Exciter/Control PWB Replacement - Exciter” on page 4.1.68
.
5.
Obtain a replacement exciter module (Nautel Part # NAE107A or newer) and install it by reversing
the instructions in
.
6.
Close the transmitter’s front door and re-install the upper, rear
panel.
7.
If it was necessary to turn RF off and disable ac power in
, enable and turn on ac power to
the transmitter.
8.
Restore the transmitter to the desired operational state. If the replacement exciter is intended to be
the main RF drive source, use the
Changeover
menu to establish the main/active exciter. Restore
the automatic changeover setting, if applicable.
Summary of Contents for GV10
