natus Nicolet V Series, Information For Use

Page: 45 / 54

8/11/16
4-3
Operation
Introduction
The V Series amplifiers require a host computer with the appropriate software to be
attached via a network cable to setup the amplifier parameters. This section is an overview
of the controls, indicators, and other features available for use on the unit.
Patient safety
The patient must be disconnected from the V Series amplifier when high frequency surgical
equipment is used.
To guard against patient injury or equipment damage, use only accessories and electrodes
identified for use with this device (see instructions for the electrodes you are using).
If an electrode/sensor is damaged in any way, discontinue use immediately.
While connected to the amplifier, the patient must not come into contact with any metal part
of the V Series Amplifier or monitoring computer, either by direct contact or through the
operator performing the test.
The correct use of the V Series Amplifier is to monitor and record physiological signals for
EEG (electroencephalography) or PSG (polysomnography).
Although the V Series Amplifier can be used to monitor biopotentials like ECG, this amplifier
should not be used as an electrocardiograph or for vital signs monitoring.
An EEG or PSG is to be used only by or on the order of medically trained personnel.
The appliance coupler (AC Cordset) is the means for disconnecting the V Series amplifiers
from the power mains.