Natus® Brain Monitor &
Embla Dx Series™
User and Service Manual
36
Powering Down the System
Utilize the following steps to ensure your system is powered down completely and safely.
1.
Close any active studies in the
NeuroWorks/SleepWorks
software.
2.
Shut the computer down; ensuring to follow the proper shut down procedure.
3.
On the base LCD press and hold the Shutdown button for 3 seconds.
4.
Unplug the power cord from the wall.
Adding the Breakout Box to a Pouch
Placing the breakout box on the patient, can be accomplished by adding it to a pouch.
The Brain Monitor & Embla Dx Series breakout box(es) should only be used in conjunction with
the
Brain Monitor & Embla Dx Series Pouch
Place only a single breakout in an individual pouch. Neither the Amplifier pouch nor the
breakout box should be covered by blankets or any other material. Failure to follow these
instructions could raise the temperature of the Brain Monitor & Embla Dx Series Breakout(s)
above normal operational levels.
To use the pouch:
1.
Attach the lanyard to the two (2) rings on the back of the pouch.
2.
After attaching the electrodes to the patient, place the Breakout Box into the pouch with the
electrode wires exiting at the top or on the sides, as required. If an external battery pack is
used, insert it into the pouch beside the Breakout Box.
3.
Close the zippers as much as possible so that the Breakout Box is secured in the pouch.
4.
Once the Breakout Box is enclosed in the p
ouch, place the lanyard around the patient’s neck
or shoulder, or hang it on the bedside post.
Insert the patient event switch into the holder on the front of the pouch and the gather the electrodes into
a ponytail.
