natus Grass S88X, User & Service Manual

Page: 37 / 64

S88X
Dual Output Square Pulse Stimulator
7-37
l
oad
s
etuP
& s
ave
s
etuP
When the POWER to the S88X is turned on, the S88X will display the last
set of parameters used. In addition, it is possible to save up to 9 sets of
stimulating parameters for use again.
S
etting up the
S88X p
arameterS
To set up the parameters to be used proceed as follows.
1.
Select the FUNCTION, PULSES, RATE, DELAY, DURATION and OUTPUT AMPLITUDE
as is appropriate for the study. b
aSic
m
oDeS of
o
peration
later in this
chapter offers many basic setups.
Note:
To increase or decrease a value use the left and right arrow touch-
pad controls to select the digit to be changed. The number that is
flashing is the number that is selected. Then use the thumbwheel
control to increase or decrease that number.
S
aving the
S88X S
etup
1. Press the SETUP touch-pad control.
2. Toggle down the list to SAVE SETUP by using the TIMING thumbwheel
control and press the ENTER/ACCEPT touch-pad control.
3. SAVE TO SETUP NUMBER x will be displayed. ( NUMBER x can be adjusted
from 1 to 9 by using the TIMING thumbwheel control.)
4. Press the ENTER/ACCEPT touch-pad control again.
l
OaDing a
S
et OF
S88X S
aveD
p
arameterS
1. Press the SETUP touch-pad control.
2. Toggle down the list to LOAD SETUP by using the TIMING thumbwheel
control and press the ENTER/ACCEPT touch-pad control.
3. LOAD FROM SETUP NUMBER x will be displayed. ( NUMBER x can be adjusted
from 1 to 9 by using the TIMING thumbwheel control.)
4. Press the ENTER/ACCEPT touch-pad control again.