https://www.naturewater.eu
Item 63922, 63923
Page 3
11 2023-1
Introduction
Thank you for choosing to purchase this quality product. To minimise the risk of injury, we ask you to
always take some basic safety precautions when using this product. Please read this operating manual
carefully and make sure that you understand it.
Keep these operation instructions in a safe place.
Use and warning notices
Prohibition symbol
Any use described with this symbol is prohibited, as otherwise the prod-
uct could be damaged, the safety of users could be jeopardised, or ma-
terial damage could be caused.
Warning symbol
Any use described with this symbol must be carried out in strict compli-
ance with the regulations, otherwise the product could be damaged or
the safety of the user could be jeopardised.
Instruction symbol
All instructions marked with this symbol must be observed by the user,
otherwise the product may be damaged or other damage may occur
due to improper operation.
•
Installation, commissioning, or maintenance of this water softener must be carried out by qual-
ified personnel.
•
Liability for consequences caused by improper installation is excluded.
Safety instructions
•
The water softener can only be supplied with 12
V and 1500 mA. Observe all safety precautions
in connection with the operation of electrical appliances during operation and maintenance.
•
If the mains cable of the water softener is damaged, it must be repaired by a qualified electrician.
•
The water softener is only suitable for filtering pre-treated tap water. It cannot be used to filter
water with an unknown level of contamination or an unknown proportion of harmful organisms.
•
The water softening liquid cannot be drunk directly. Do not drink it directly.
•
Do not block the overflow pipe and the drain pipe of the water softener.
•
Do not place any objects on the water softener.
•
Do not immerse the water softener in water.
•
Do not use the water softener outdoors or in direct sunlight.
•
The temperature of the water entering the treatment device must not exceed 38
℃
.
•
After the water softener has been out of operation for a certain period of time, manual treatment
must be carried out before reuse to ensure the quality of the water produced.
•
The power supply must not be interrupted while the water softener is in use in order to avoid
timing errors of the water softener, which would affect the originally set regeneration start time
of the water softener. Otherwise, users could misuse water that has not yet been softened.
•
If the water consumption increases significantly (compared to normal consumption) or the hard-
ness of the raw water increases, the regeneration cycle must be shortened accordingly or the
hardness of the raw water must be adjusted so that the regeneration times are extended.
•
As hot water can severely damage the internal treatment system, it should be ensured that there
is a connecting pipe of at least 3
m in length between the outlet of the softener and the inlet of
the hot water boiler. If the 3-m connection line cannot be assured, it is recommended to install
a non-return valve between the water softener and the hot water boiler.
