https://www.naturewater.eu
Item 63922, 63923
Page 13
11 2023-1
5.
After completing the installation steps in step 4, check whether the bypass is in “water supply”
(service) mode (Fig.
1). If the bypass is in bypass mode (Fig.
2), pull the push rod into the “water
supply” position (Fig.
1).
Diagrams of the “water supply” mode
“Water supply” mode
“Bypass” mode
Fig.
1
Fig.
2
№
Name/description
№
Name
1
Bar
4
Clamp
2
Bypass
5
Press push rod, set “Water supply” position
3
Flow meter
6.
After completing the installation steps in step 4, check whether the bypass is in “water supply”
(service) mode (Fig.
3). If the bypass is in bypass mode (Fig.
4), pull the push rod into the “water
supply” position (Fig.
3).
“Water supply” mode
“Bypass” mode
Fig.
1
Fig.
2
№
Name/description
№
Name
1
Bar
3
Flow meter
2
Knob handle
4
Press push rod, set “Water supply” position
7.
Treatment of bypass valves in special cases: In the event of a failure of the device or other
special circumstances, the bypass valve of the machine can be set to the bypass state (push
the pull rod to the operating position as shown in Fig.
3). You can temporarily use the municipal
water supply directly. Once the fault or problem has been rectified, set the bypass valve to the
operating position (push the pull rod to the position shown in Fig.
2) to restore the soft water
supply.
