▪
center: Triangle
▪
right end: Sawtooth
Morphs from Sine to a slightly smoothed Triangle. Between Triangle and Sawtooth the symme
try is bent and an amplitude windowing is increasingly applied to the sample reader output.
[2] LFO: LFO amount for the pitch. At negative values the LFO phase is inverted.
[3] ENV: Amount of pitch modulation by the Envelope [in semitones].
[4] FEEDBACK: Amount of phase modulation by the feedback signal
[5]
PB
: Pitchbend amount for Oscillator A [semitones].
[6]
PITCH
: Pitch of Oscillator A at C3 (MIDI note 60) in semitones (based on MIDI note num
ber). The range below zero is shaped in the way that -20 refers to 0 Hz. If the key tracking is
zero, the pitch is used for all keys..
[7] KEY TRACKING: Key tracking of the oscillator pitch. It's the scaling factor between the key
position of a received MIDI note (relative to C3=60) and the pitch of the oscillator. At 1.0 the
pitch follows the equally tempered scale. At values slightly larger than 1.0 you get a stretched
tuning. At 0.0 the oscillator frequency is independent from the note pitches.
[8]
A
: Attack time 0.1 - 10000 ms.
[9]
D1
: Time of the first (linear) Decay segment 1 - 10000 ms.
[10]
B
: Level of the Breakpoint between the two Decay segments.
[11]
D2
: Time of the second (exponential) Decay 1 - 10000 ms.
[12]
S
: Sustain level.
[13]
R
: Release time 1 - 10000 ms.
[14] ENV Display: Visual display of the envelope for Oscillator A.
[15]
V
: Influence of the key velocity on the peak and sustain levels of the envelope:
▪
0: no influence, full levels
▪
0...1: increasing influence by the velocity
▪
1: full control by velocity, dynamic range: 43 dB.
Overview of SKANNER Ensemble
Modulators Section
SKANNER - Manual - 43
Summary of Contents for Skanner
Page 1: ...Manual...
