KORE 2 – 175
Label
Function
Range
Unit
Mix Dry-Wet
Sets the balance between the dry, unprocessed signal and the “wet” (filtered)
one.
0..100
%
Center
Changes the cutoff frequency of the internal allpass filters of the Phaser, lead
-
ing to a shift in phasing frequencies. This interacts with the modulation, as it is
added to this value (have a look at the Modulation Meter).
0..100
%
Modulation Sync
Synchronizes the frequency of the LFO to KORE 2’s time base.
On/Off
Modulation Rate
Adjusts the delay time modulation speed, i.e., the internal LFO’s frequency.
0..10
Hz
Modulation Depth
Sets the amount of modulation as a percentage of the delay time
0..100
%
Modulation LR Phase
Sets the phase offset of the LFO modulating the right or left channel delay
times, respectively. At the maximum setting the
0..180
De-
grees
Color Feedback
Feeds the output of the chain of allpass filters back into its input leading to a
shift in phasing frequencies.
-100..+100
%
Color Bandwidth
This influences the way the phase rotation changes with higher frequencies lead
-
ing to a different set of peaks and dips in the spectrum. Higher settings spread
the frequencies at which the peaks and dips sit.
0..100
%
Color Low Cut
Sets the cutoff frequency of a lowpass filter in the chain of allpass filters. Use
this to block out unwanted low frequency resonances.
25..800
Hz
Invert Mix
If on, the processed signal is phase-inverted before being mixed with the input.
On/Off
