Page 16
BELT
The machine uses a 4L-330 belt smooth or cogged. Cogged belts give a better grip to the pulley.
TO REMOVE OR CHANGE BELT
Unplug machine from power source. Remove the cover. Loosen the four bolts on the motor base See
Figure 21). Slide the motor base forward enough to remove belt. Replace belt (See Figure 22). Tilt
machine backwards (See Figure 23) and slide motor base back until the belt is tight. Make sure the belt
is in proper alignment between the two pulleys (See Figure 22). When proper tension on the belt is
achieved, retighten the four motor base bolts. Replace the cover.
PULLEY CHANGE OUT
The machine comes set-up with a large pulley and a small pulley (See Figure 24). This gives higher
torque, less speed. To increase the speed of the machine change the front (large) pulley to the small
pulley included with the machine. This will allow for lower torque, higher speed.
PROCEDURE
Figure 22
Figure 21
Motor Base
Bolts
Figure 23
WARNING:
Never run machine without protective covers (Belt cover, Disc Shroud, etc.) Failure to
do so could cause serious injury.
Belt
Slide Motor
Base back
Figure 24
Belt
Small pulley
Large pulley