Page 13
REMOVING OR CHANGING THE SHROUD
Unplug machine from power source. Failure to do so could cause damage to machine or serious bodily
injury. Remove the flower washer. Remove the disk or the cup plate. Remove the four shroud securing
screws (See Figure 9). Remove shroud. Slide new shroud over the disk shaft. Replace the flower washer
and the four shroud securing screws.
SHROUD IN EDGER MODE
For the 10'' shroud, connect the shroud to the shroud securing clip (See Figure 10). For the 7'' shroud,
flip the front up (See Figure 11). To run this machine in the Edger mode, the handle will need to be
adjusted and wheels will need to be rotated. Refer to these applications in the manual for specific
instructions.
PROCEDURE
Figure 10
Figure 9
Shroud securing
screws
Shroud securing
screws
Figure 11
Securing
clip
DO NOT OVERREACH. MAINTAIN CONTROL:
Keep proper footing and balance at all times. Maintain a firm grip.
WARNING:
Exposure to dust may cause respiratory ailments. Use approved NIOSH or OSHA
respirators, safety glasses or face shields, gloves and protective clothing. Provide adequate ventilation
to eliminate dust, or to maintain dust level below the Threshold Limit Value for nuisance dust as
classified by OSHA.
WARNING:
Always wear respirator protection, appropriate for the application, as specified by
OSHA regulations and your employer. Never operate or maintain equipment before reading and
understanding the instructions for operation and maintenance. Obey all safety signs and instructions
while operating or maintaining equipment.
Flower
washer