![background image](http://html.mh-extra.com/html/national-instruments/vxi-tb-1000/vxi-tb-1000_installation-manual_710241003.webp)
3
Installing Your Terminal Board
Perform the following steps to install the terminal board. The numbers in
parentheses refer to items in Figure 1.
1. Loosen the three cover screws (6) with a Phillips-head number 1
screwdriver. These screws stay attached to the cover (5) without
falling out.
2. Remove the cover (5). You now have access for installation.
3. Place the terminal board (7) into the appropriate half of the terminal
board carrier.
4. Install and tighten the four board screws (8), included with the board,
using a Phillips-head number 1 screwdriver.
5. If you are using only one terminal board, you need to install the
safety shield (10) included with the VXI-TB-1000. Place the safety
shield over the screw bosses (15) and tighten the two safety shield
screws (4), included with the shield, to the screw bosses.
Warning:
You must install this safety shield to prevent access to high-voltage
signals.
6. Install the user help card (14) into the raised slots of the cover
insulator (13).
You are now ready to make your signal connections.