![background image](http://html.mh-extra.com/html/national-instruments/vxi-tb-1000/vxi-tb-1000_installation-manual_710241006.webp)
6
Figure 2 shows the screw terminal board inside the uncovered
VXI-TB-1000 terminal board carrier with one terminal board.
2
1
1
Wire Opening
2
Screw Terminal Board
Figure 2
. VXI-TB-1000 Screw Terminal Board
Installing Your Terminal Block
Perform the following steps to connect the terminal block to the
VXI-DAQ module front panel connector. The numbers in parentheses
refer to items in Figure 3.
Note:
Before attaching the terminal block onto the VXI-DAQ module front panel
connector, make sure the VXI-DAQ module attachment screws (1) are
tightened to the VXIbus chassis.
1.
Guide the terminal block onto the VXI-DAQ module front panel
connector (7) by aligning the terminal block handle recess area (3)
to the ejector handles (2) on the VXI-DAQ module.
2.
Connect the VXI-DAQ module front panel connector to its mating
connector (6) on the terminal block.
3.
Tighten the top and bottom mounting screws (5) on the back of the
terminal block to hold it securely in place.