![background image](http://html.mh-extra.com/html/national-instruments/tb-2715/tb-2715_installation-manual_710189005.webp)
©
National Instruments Corporation
5
TB-2715 Terminal Block Installation Guide
7.
Insert the stripped wires into the screw terminals. If you are using a
shielded cable, expose the shield and allow it to make contact with the
EMI gasket.
8.
Tighten the screws with the 0.10 in. slotted screwdriver.
9.
Connect safety ground or shield wires to the chassis ground connection
tab using the provided solder lug and ground lug screw.
10. Tighten or replace the strain-relief screws.
11. Replace the terminal block cover and tighten the cover screws.
Connecting the TB-2715 to Your PXI Module
Refer to Figure 5 as you perform the following steps to connect the
terminal block to your PXI module.
Figure 5.
Connecting the TB-2715 to Your PXI Module
1.
Install your PXI module into the chassis and tighten the two module
screws. You
must
install the PXI module in the PXI chassis before the
TB-2715 is connected to the PXI module.
2.
Guide the terminal block onto the module connector.
3.
Tighten the two terminal block mounting screws.
Caution
Insert the terminal block as shown in Figure 5. The TB-2715 can be attached to a
PXI module only one way. Do not force the terminal block when attaching or removing it
to avoid damaging the TB-2715 or PXI module.
1
Terminal Block Mounting Screws
2
PXI Chassis
3
PXI Module Connector
1
1
8
7
6
5
4
3
2
2
3
Summary of Contents for TB-2715
Page 6: ......