3
user manual to make sure that your module supports the mode you
want to use and that you have properly configured the necessary
jumpers on your SCXI module.
+5 V
+5 V
100 k
Ω
100 k
Ω
DIOA(0)
of Module
Connector
DIOA(0)
of Module
Connector
DIOA(0)
of Breakout and
DAQDIO 6533
Connector
DIOA(0)
of Breakout and
DAQDIO 6533
Connector
P
SW1
S
P
SW1
S
a. Parallel Mode Setting
(Factory Default)
b. Serial Mode Setting
Figure 2. SCXI-1355 Adapter Board Switch SW1 Settings
4.
Plug the socket connector of the SCXI-1355 adapter board into the
rear signal connector of an SCXI module.
5.
Secure the SCXI-1355 adapter board by screwing the two small
screws through the rear panel of the adapter board and into the
threaded strips in the back of the SCXI chassis.
6.
Connect one end of the SCXI-1355 cable to the 68-pin connector of
the SCXI-1355 adapter board.
7.
Connect the other end of the cable to the I/O connector of the
DAQDIO 6533 Series board.
8.
Secure the cable to a fixed object with the tie wraps to relieve the
strain on the cable. Strain relief is necessary because the SCXI-1355
shielded cable has a long, stiff backshell that can exert leverage on
the DAQDIO 6533 Series board connector.
Summary of Contents for SCXI-1355
Page 7: ......
