2
❑
DAQDIO 6533 Series AT-DIO-32HS or PCI-DIO-32HS board with
a 68-pin SCSI type II connector
❑
Small Phillips-head screwdriver
❑
Small flathead screwdriver
❑
Your computer
Installation
Figure 1 shows the components of your SCXI system and how to connect
them.
SCXI Module
Adapter
Board
Step 4
Step 5
Step 6
Shielded Cable
Step 7
DAQDIO 6533
Board
Figure 1. SCXI System Components
Perform the following steps to install the SCXI-1355 cable:
1.
Turn off the power to your computer and the SCXI chassis.
2.
Install your SCXI modules in the SCXI chassis, following the
instructions in your SCXI module user manuals.
3.
Set the adapter board switch for parallel mode (P) or serial mode (S).
See Figure 2, which also shows the circuit on the DIOA(0) line, for
each switch setting.
Use the adapter board, the SCXI module, and DAQDIO 6533 Series
board in parallel mode when you want each DIO line to be directly
conditioned by an SCXI module channel to which you cable.
Use the system in serial mode when you want to use the
DAQDIO 6533 Series board as a communication device to control
one or more SCXI modules in the chassis. Check your SCXI module
Summary of Contents for SCXI-1355
Page 7: ......
