SCXI-1160 Cabling
Appendix E
SCXI-1160 User Manual
E-2
© National Instruments Corporation
•
The SCXI-1340 rear panel gives the module and the chassis both mechanical and electrical
shielding.
Table E-1 lists the pin equivalences of the MIO-16 and DIO-24 boards and the SCXI-1160.
Table E-1. SCXI-1160 and Board Pinout Equivalences
Pin
SCXI-1160 Rear Signal
Connector
MIO-16 Board
Equivalent
DIO-24 Board
Equivalent
24
DIG GND (MIO)
DIG GND
25
SERDATIN
ADIO0
PB3
26
SERDATOUT (MIO)
BDIO0
27
DAQD*/A
ADIO1
PB2
29
SLOT0SEL*
ADIO2
PB1
31
SERCLK (DIO)
PB0
37
SERCLK (MIO)
EXTSTROBE*
47
SERDATOUT (DIO)
PA0
50
DIG GND (DIO)
DIG GND
No other pins are connected on the SCXI-1160.
SCXI-1340 Installation
Follow these steps to install the SCXI-1340:
1. Make sure that the computer and the SCXI chassis are turned off.
2. Install the SCXI module in the chassis.
3. Plug the mounting bracket connector onto the module rear signal connector (see Figure E-1).
An alignment tab on the bracket enters the upper board guide of the chassis.
4. Screw the mounting bracket to the threaded strips in the rear of the chassis.
5. Connect the loose end of the cable assembly to the MIO-16 or DIO-24 board rear signal
connector.
Check the installation.
After step 1, the order of these steps is not critical; however, it is easier to locate the correct
position for the mounting bracket with a module installed in the chassis. If you are attaching a
cable to the breakout connector, installation is easiest if you attach the second cable before
installing the SCXI-1340.