©
National Instruments Corporation
27
NI Switches Getting Started Guide
12. Click the
Accessory
tab (if available). Select the terminal block
connected to the switch module from the
Accessory
list box.
Figure 19.
Configuring Switch Modules under Traditional NI-DAQ Devices in MAX
13. Click
OK
to accept the settings.
9. Connecting Signals
Complete the following steps to connect signals to the switch module:
1.
Wire sensors to your switch module or the terminal block. For signal
connection information, refer to the terminal block installation guide
or the
NI Switches Help
.
Caution
Always refer to the specifications document included with your switch
before
connecting signals. Exceeding specified switch signal ratings can create a shock or fire
hazard and damage any or all of the devices connected to the switch.
Caution
Modules that share a common HVAB derate to their lowest common voltage
rating, even if signals are not connected to the backplane. Refer to the
section for more information.
2.
Connect the module front connector to its mating connector on the
terminal block.
3.
Tighten the top and bottom thumbscrews on the back of the terminal
block rear panel to hold it securely in place.
