2-6
|
ni.com
Chapter 2
DAQ System Overview
You can use one BNC accessory on connector 0 of any X Series device. An additional BNC
accessory may be used on connector 1 of any X series device except the NI 6345/6349/6355/
6365/6375
devices. The BNC-2115 can only be used on connectors 1, 2, or 3 of the NI 6345/
6355/6365/6375
devices and connector 1 of the NI 6349 device.
Screw Terminal Accessories
National Instruments offers several styles of screw terminal connector blocks. All terminal
connector blocks require a cable except the TB-2706
to connect an X Series device to a
connector block, as listed in Table 2-2.
RTSI Cables
Use RTSI bus cables to connect timing and synchronization signals among PCI/PCI Express
devices, such as X Series, M Series, CAN, and other measurement, vision, and motion devices.
Since PXI devices use PXI backplane signals for timing and synchronization, no cables are
required.
Cables
You can use the following cables:
Table 2-2.
Screw Terminal Accessories
Screw Terminal Accessory
Description
CB-68LP and CB-68LPR
Unshielded connector blocks
SCC-68
I/O connector block with screw terminals,
general breadboard area, bus terminals, and
four expansion slots for SCC signal
conditioning modules.
SCB-68
Shielded connector block with temperature
sensor
SCB-68A
Screw terminal block with temperature
sensor
TBX-68
DIN rail-mountable connector block
TB-2706
*
Front panel mounted terminal block for
PXI Express X Series devices
*
TB-2706 (not for use with NI 6345/6346/6349/6355/6365/6375 devices) uses Connector 0 of your
PXI Express device. After a TB-2706 is installed, Connector 1 cannot be used.
Summary of Contents for PCIe-6323
Page 1: ...PCIe 6323...
