National Instruments PCI-8430, Manual

Page: 52 / 237

Adding a Serial ENET Interface
LabVIEW RT users do not need to add serial ENET interfaces to their RT
controllers. To use a serial ENET interface on your LabVIEW RT system,
you simply configure it. Refer to
Viewing Network Settings for instructions
on viewing and configuring network settings for serial ENET interfaces.
To add a serial ENET interface on your Windows system, complete the
following steps:
1. Launch MAX .
2. Right-click Devices and Interfaces and select Create New... .
3. In the Create New... dialog window, select Serial ENET Interface
and click Finish .
4. Follow the prompts in the Add Serial ENET Hardware Wizard to
add your serial ENET interface.
If the PWR/RDY LED continues to alternate rapidly between red
and yellow, the unit could not use DHCP to configure its network
parameters. You need to use the NI Ethernet Device
Configuration utility to configure your serial ENET interface. Refer
to
Configuring Network Settings for more information.
5. When finished, select Restart Now to finish the serial ENET
installation.
6. After the computer has finished restarting, continue to Verify the
Installation .