Chapter 1
Introduction
NI PCI-7342 Hardware User Manual
1-4
ni.com
ANSI C-based LabWindows/CVI also features interactive graphics and a
state-of-the-art user interface. Using LabWindows/CVI, you can generate
C code for custom data acquisition, test, and all measurement and
automation solutions.
NI-Motion is the motion control software and virtual instruments (VIs) for
interfacing with all National Instruments motion controllers.
Optional Equipment
The following optional products are available for use with the National
Instruments motion controllers:
•
Cables and cable assemblies for motion and digital I/O
•
RTSI bus cables
•
UMI wiring connectivity blocks with integrated motion signal
conditioning and motion inhibit functionality
•
Stepper and servo motor compatible driver amplifier units with
integrated power supply and wiring connectivity
•
Connector blocks, shielded and unshielded 68-pin screw terminal
wiring aids
For specific information about these products, refer to the National
Instruments catalog, the National Instruments Web site at
ni.com
, or call
your National Instruments sales representative.
Motion I/O Connections
The external motion I/O and digital I/O connectors are high-density, 68-pin
female VHDCI connectors. Refer to the
section of
Chapter 3,
, for more information about these
connectors.
For custom cables, use the AMP mating connector (part number
787801-01).
