Doing so can damage the device and the computer. National Instruments is not liable
for damage resulting from such a connection.
The power rating is 4.75 to 5.1 VDC at 0.5 A.
Autonomous Mode
You can run the NI USB-7845R OEM device without a USB connection to a host computer
using Autonomous Mode. To collect data the NI USB-7845R OEM device acquires in
Autonomous Mode, you must reconnect the NI USB-7845R OEM device to a host computer.
Caution
Data is lost and is not recoverable upon reconnection if a DMA FIFO
overflows while the NI USB-7845R OEM device is disconnected from the host
computer or if the NI USB-7845R OEM device loses power at any point.
Autonomous Mode includes the following capabilities.
Table 5. Autonomous Mode Capabilities
Capability
Description
Use the Open/Close FPGA
Reference VI functions to
run an FPGA VI and then
disconnect the USB cable.
Call the Close FPGA VI Reference Function without aborting
or resetting the FPGA VI before you disconnect the USB
cable.
1
After you disconnect the USB cable, any VI running on the
NI USB-7845R OEM device continues to run and collect data,
which can later be retrieved by reconnecting the USB cable
and re-opening the original FPGA reference.
Use Interactive Front Panel
Communication to run an
FPGA VI and then
disconnecting the USB
cable.
The front panel indicators stop updating.
After you disconnect the USB cable, any VI running on the
NI USB-7845R OEM device continues to run. Restore the
Interactive Front Panel Communication by reconnecting the
USB cable.
Download the bitfile to
flash memory and set it to
run when loaded to FPGA.
Download the bitfile to flash memory and set it to run when
loaded to FPGA. The bitfile automatically starts running
whenever power is applied to the
NI USB-7845R OEM device. To collect data, you must
reconnect the NI USB-7845R OEM device to a host computer
before powering off the device.
Refer to the
LabVIEW FPGA Module Help
for more
information about downloading an FPGA VI to the flash
memory.
1
The Host VI errors out if you do not call the Close FPGA VI Reference Function without aborting
or resetting the FPGA VI.
NI USB-7845
R
OEM User Manual
|
© National Instruments
|
13
